Logo
FULL SITE MENU

84 merc 50hp lower end cap

Q

Qbanredneck

Contributing Member
Hello all,
working on replacing seals on lower crankshaft. While I have engine off any other things You recommend I do since it’s off?

MORE importantly, I have seloc manual and forgot to pay attention to the direction the two seals should be. Manual doesn’t seem to cover that point at least I haven’t seen it.

I didn’t seem to see a shim from what manual shows.

thanks all
 
Last edited:
???----Shims are used to get correct end float on the crankshaft.------You may need none on your block.----You may need 2 of them.------This is called " fine fitting "-----If you are not sure on the concept get a shop to check it for you !!
 
Back
Top