Logo
FULL SITE MENU

1990 Evinrude 90 hp tilt won't go down

R

riopga

Regular Contributor
My tilt-n-trim works fine going up but does not want to go down. As long as it doesn't go very far up it will come down.
But if I go more than about 45 degrees, the motor sounds like it is trying to lower it but no movement.
If I use the manual release it will come down.
I have tried greasing the shaft.
 
That did it. I foolishly thought that if it would go up it had enough fluid. Obviously not. Thanks for the help.
 
Back
Top