Valenteman
New member
I have been scanning the internet for almost a year on any video on how to replace the upper rubber mounts in my 98' Mercury 9.9hp 2 stroke tiller engine. I can't seem to figure out whats involved in replacing it. It seems you need to separate the drive shaft housing from the swivel head. But i'm lookin to see if anyone has experience with this that can help lead me to water here.
This is the mount i'm talking about:
These are from the diagrams to give a better look (Driveshaft housing):
This is from the swivel head. This is where the mounts sit in the swivel head:
Any help would be greatly appreciated.
This is the mount i'm talking about:
These are from the diagrams to give a better look (Driveshaft housing):
This is from the swivel head. This is where the mounts sit in the swivel head:
Any help would be greatly appreciated.