Mikey N.C.
Advanced Contributor
Ok guys I've got another situation, motor runs balls to the wall, 5-6-10 miles,
Shut down motor for 10 minutes. Crank and motor will not get on plane, and acts like limp mode , but no alarm.
Cleaned OX-66 sensor last year ran great . Now last week starting doing same thing. OX-66 I took back apart had oil in it but no carbon build up.
My Question is if TPS can get off wouldn't I have that , operation condition from the start up of motor.?? Now I've tested the temperature sensor, it's in omhs as far as heating water. Now motor has 2 over heat sensors on both heads, I can find how to test. I'm replacing both thermostats
, And gaskets. I know temp. Sensor is good but don't know about overheating switches. Is my situation oiler out of sync. Both thermostats open in pot of water.?? I'm asking for help.
Shut down motor for 10 minutes. Crank and motor will not get on plane, and acts like limp mode , but no alarm.
Cleaned OX-66 sensor last year ran great . Now last week starting doing same thing. OX-66 I took back apart had oil in it but no carbon build up.
My Question is if TPS can get off wouldn't I have that , operation condition from the start up of motor.?? Now I've tested the temperature sensor, it's in omhs as far as heating water. Now motor has 2 over heat sensors on both heads, I can find how to test. I'm replacing both thermostats
, And gaskets. I know temp. Sensor is good but don't know about overheating switches. Is my situation oiler out of sync. Both thermostats open in pot of water.?? I'm asking for help.