I was replacing my water pump I tried to reinstall my lower unit there appears to be a metal right blocking the splines. I suspect it the retainer ring that came off the bottom of the crankshaft. i started to pull the power head since this used in saltwater I assume it's going to take some effort to remove the power head. My other thoughts is can I just remove the drive shaft housing instead.
Is it possible to pull the driveshaft housing instead of the removing the power head to access the lower portion of the crankshaft ? Since this used in saltwater I assume it's going to take some effort to remove the power head.
Thanks in advance.
Is it possible to pull the driveshaft housing instead of the removing the power head to access the lower portion of the crankshaft ? Since this used in saltwater I assume it's going to take some effort to remove the power head.
Thanks in advance.