Newport Dave
New member
I had my outdrives serviced this season. I personally inspected with the technician everything looked clean, u-joints, etc. We replaced billows just in case and did standard service. Last time I was out I felt more vibration than normal. Someone told you can get that if the drives are switched on the gimbals they are warn into. The mechanic stated they marked them an reinstalled and yes their (s)&(p) marks match including props. But later when I looked at serial numbers on motors they are swapped, double and triple checked. Not terribly worried but I keep thinking about it.
Is it bad to switch drives port to starboard on the original gimbals?
thanks
Dave
Is it bad to switch drives port to starboard on the original gimbals?
thanks
Dave