Hi folks, I have a parsun 2.6 hp 2 stroke for my fishing boat. As a result of an accident the motor went to the bottom of a lake where I managed to rescue. I dissambled it cleaned and briefly tested back at home ( without water tank) and everything was aparently ok ... in dry starting! when I decided to go fishing again and the motor was with the prop in the water just a few turns and it cuts off. NBack at home, started it whitout water and started working inmediatly, then I tryed to start it in a tank and situation repetaed , just few turns and cut off. I cant figure what I did wrong in assemblyng process- any idea will be more than wellcome! I live in a pretty remote area in south america, fishing is great but workshops and mnechanics are not easyly avaliable!

regards!

Alfredo