FstaRockr Burns
Regular Contributor
Hi need help - i am wiring the 8 lug terminal block on a evinrude - I have 2 wires left I cant account for - they go to a round odd shaped black molded thing that sits behind the pack - no clue what this is.. blocking diode or maybe a tilt/cut switch? see pins 4 and 5 in the diagram below - they go to a round black molded rubber thing - thats it.. not sure what that is?
Following this diagram:
can anyone shed some light?
heres a pic of the black molded thing:
2 wires - not sure where they connect to?
PO had one on the red going to batt but in the manual it doesnt show this?
Wanna tie these last 2 up before firing it up - thanks
Following this diagram:
can anyone shed some light?
heres a pic of the black molded thing:
2 wires - not sure where they connect to?
PO had one on the red going to batt but in the manual it doesnt show this?
Wanna tie these last 2 up before firing it up - thanks
Last edited: