MD11/C waterpump

berwick · Dec 22, 2021

On an MD11/C how the heck do you remove the pipe that goes into the end of the pump (the circled part), nothing seems obvious to me.

thank you

Richard

o2batsea · Dec 23, 2021

It's sealed with an o-ring. Just pulls out. Clean inside and also the seating area of the pipe when installing new o-ring. A little bit of soapy water helps it slide into place. We had one of these old lumps in our Pearson Vanguard when I was a lad.
Item #20 on the diagram here:
7742230_032

https://www.amazon.com/Volvo-Penta-Ring-Sealing-418411/dp/B007I915DC

berwick · Dec 23, 2021

OK, it did not want to move for me, just need to pull on it more then,

thank you

Richard

o2batsea · Dec 23, 2021

Guh-dunk, Guh-dunk, Guh-dunk, Guh-dunk, Gah-dak, Gah-dAK, Gah-DAK, GAH DAK GAH DAK Uh Dak Uh Dak Uh DAK DAKKA DAKKA DAKKA DAKKA

MD11/C waterpump

berwick

New member

Attachments

o2batsea

Outstanding Contributor

berwick

New member

o2batsea

Outstanding Contributor

Outboard Motor Parts

Inboard & Sterndrive Engine Parts

Manufacturer Catalogs

All Engine Brands

Outboard Repair Manuals

Inboard & Sterndrive Engine Manuals

Shop by Accessory Category

Please Note

Join the Forum

Discussion Topics

Outboard Motors

Inboard & Sterndrive Engines

Contact & About

Ordering

Returns

MD11/C waterpump

berwick

New member

Attachments

o2batsea

Outstanding Contributor

berwick

New member

o2batsea

Outstanding Contributor