Logo

How to locate top dead center on TAMD41A

Captain Todd

New member
I must have run into an older version of the TAMD41A and I don't know how to locate top dead center without pulling an injector. The bell housing does not have the hole to use the locater pin tool. I must be overlooking something but dang if I know what it is. No mention of it in the shop manual either. Any help would be most appreciated.
 
I must have run into an older version of the TAMD41A and I don't know how to locate top dead center without pulling an injector. The bell housing does not have the hole to use the locater pin tool. I must be overlooking something but dang if I know what it is. No mention of it in the shop manual either. Any help would be most appreciated.
Just for future reference, I found it back in the archives. The 41 Series have the service port on the starboard front of the bell housing up at the top. KAMD42's all the way to the 300 have the service port on the port side above the flywheel. Hope this helps someone.
 
Back
Top