Logo
FULL SITE MENU

ignition coil replacement

olddaddy75

olddaddy75

New member
Does anyone know if there is a replacement coil to replace FS474475? This coil in not available, maybe someone has one they would sell me. Maybe any 12 volt coil that would fit under the cover would work, does anyone have any advice for this? This is for a 79 55 HP Chrysler with magnapower, 559H9L.
 
Ebay just put the part# in the subject line and some show up.
As far as using an automotive coil, the results aren't usually any good.
You can change to an auto system, check her and Utube videos.
 
Flywheel woodruff key was sheared. Still no spark. Will replace the CD module, I have one, and a capacitor, but ordered one trigger. That is all the fellow had, unless I buy the whole bracket with two on it for 139 dollars. My reasonable cost boat is really costing a lot.
 
Took the moneypit to the lake, reverse jumps out. Took it apart, and the dogs on the slider were rounded off, so I am removing the metal on the rounded edges, the reverse gear looks pretty good. If I make the dogs on the slider square again, it should work. I did that to my Yamaha XS11, and works fine the last 6 years.
 
Back
Top