Logo
FULL SITE MENU

350 Bravo Timing

If there's no spark at the plug and you can still "see" timing, likely issue with plug itself or "boot/connection" @ plug... And .... need more engine info.
 
Last edited:
If you take the wire from the coil to the center of the disti and pull it from the cap and hold that end very near the block and crank do you see a spark????
 
Most likely you have a Thunderbolt V without knock control.
Where the wires from distributor go, what does that module look like?
Is it a single connector at the module or two connector.
That module is the "timing control" module.

Single connector or just wires means pre knock sensor.

Also there is a step by step process to trouble shoot the ignition.
I am mobile so cant upload now.
Maybe someone else can
 
They are all that way.
Its were they go...they connect to other wires which go to a timing module.
That is what also should be identified to know if you have TBV with or without the knock sensor...
 
Did the engine ever run?
If it did then I am not sure what your asking about.
The timing module/amplifier may be mounted on the exhaust elbow.
 
Back
Top