i am working on a 2008 marine power and it started fine this season, but once in the water she died after running like crap, now i get no crank, dash info says no power detected from ECM. i looked all over the place and can't find the DLC connector to plug the scanner in and check the ECM. i did find 3 wires tied back by the ECM with wire conectors on them, orange, white and blue. i am thinking the conector should be there and the PO did something. the boat is new to my customer this season.
also, if anyone knows were the engine info is located, i would like to see that as well. its a small block engine so im guessing its a 6.0
i checked poower the the main breaker on top of the engine, thats ok, battery is good, i jumped the starter and the engine spins. but turning the key gets nothing, no fuel pump hum, no solenoids clicking.
thanks guys
also, if anyone knows were the engine info is located, i would like to see that as well. its a small block engine so im guessing its a 6.0
i checked poower the the main breaker on top of the engine, thats ok, battery is good, i jumped the starter and the engine spins. but turning the key gets nothing, no fuel pump hum, no solenoids clicking.
thanks guys