Logo
FULL SITE MENU

Adding tilt switch on MFS30 Big Tiller

M

merc200dalarna

Contributing Member
I have 'arthritis' in my right shoulder that really isn't working with reaching over to trim the motor while getting on plane.

Could it be possible to add a 3-way-switch, non locking, by jump solder some wires from the existing assy below throttle on the tiller handle?
And somehow fit such switch at the end of the throttle for 'left-thumb-access'?

Any 3-way-switch from an electronics store with a 'non-locking' 3-way function?

Yes, it might be a little 'diy', but it should work, right?

Advice?
 
Yes it has the trim/tilt.

And I'll just copy the wires going to the existing button in the 'bottom cowl' of the multitiller.
3way.jpg Perhaps I try to make room for that type of button, or Ill make a little 'housing' for it in thin sheet metal. It'll be fine.
Thanks.
 
Back
Top