David Goldfarb
New member
Hello to fellow forum members: I need advice. I just installed a water pressure sensor for the new 175 hp. Vmax Sho on my son's boat. My understanding is that an icon on the 6YC gauge should then appear however this icon is not present on the gauge. All other function on the display are functioning as they should. Our trial run and break in period was yesterday when I noticed this problem. Does anyone have knowledge as to where I should start troubleshooting this problem. It was very simple to install the new sensor and connect it to the wire harness marked W so I really don't see what could have gone wrong with this. Perhaps another wiring problem? Any suggestions of what I should do would be greatly appreciated.
Sincerely, David
Sincerely, David