Help please I’ve rebuilt the carbs so I feel like they should not be my problem. I’m following the general cold starting procedure others find works but I’m having to wind it over many times to finally get running. The fuel primer bulb stays hard for some time if I pump it so I don’t think I have any bad fuel leaks. The age of the plugs is unknown. I pulled the fuel line off and tested the pump it seems to be pushing fuel ok. This motor only has about 100-105 psi on all cylinders which I know is low but it wasn’t as difficult to start on our first run and had that compression then too. It has an electric choke which appears to be working.
The reason I rebuilt the carbs was the motor was prone to flooding easily.
Once it’s running it idles fine and fires up easily.
If I can be pointed in the right direction to start looking that would help a lot.
The reason I rebuilt the carbs was the motor was prone to flooding easily.
Once it’s running it idles fine and fires up easily.
If I can be pointed in the right direction to start looking that would help a lot.
Last edited: