shanemedearis
New member
Motor was running fine. I turned it off. Five minutes later I tried to restart it and it would not start. It turns over but will not start. At this point I checked to make sure it was getting fuel and it was. Next I check to see if it getting fire. So I pulled the plug held it to metal part of the engine to confirm the plug was firing. When I turned the key it cranked up on two cylinders. So I turn it off put the plug back in and turned the key, turns over will not crank. So I pull the plug back out and it cranks on two cylinders. This time I take the plug wire off the plug and with the engine still running I try to put the plug back in the 3rd cylinder and as soon as I put the plug in the motor goes dead and will not crank until I pull the plug out. Sound crazy and make no since. I even stared the motor with the plug out and stuck my finger in the plug hole and it immediately died. Any thoughts on what would cause this and or how to fix it. Thanks.