Logo

Coil Locating Ring 317001

A couple of clicks on this site and it will be on your door step.-----Just a little under $100.----Box at the top of this page.----Enter the part #-------I have that tool.----If I was desperate for one I would take a scrap flywheel and cut away most of it so that I could set the coils with a feeler gauge.------Or simply use the coil mounting bosses to set them !
 
Last edited:
The advice of Racer is also very good. When you carefully set coils to the inner edge of chamferr, you rarely will get insufficient clearance. If you get a rub, then it's time to address the stator bushing.
 
Back
Top