Logo
FULL SITE MENU

Help with MAP connector/wiring

C

carboncow

Contributing Member
While trouble shooting injector issues after installing a new long block it was discovered the MAP wiring had disintegrated at the sensor. I'm sure I could get an ok job on this but I really need a new harness that I can splice in.

Where would I source this connector and what do you call it? Photos attached to show the hot mess!

IMG_6210.jpeg IMG_6200.jpeg
 
Last edited:
Delphi Weather Pack is the popular brand name....I would suggest you search on line and get a kit, with the pins and sockets and crimpers...95% of the time you can reuse the shells....
 
And if you can't find the exact match, replace both ends ( probably a good idea anyway) ANY waterproof connector with the same or greater pin count will do.. Per Makomark... Be careful, as I recall the last time I ordered from these folks, the connectors were not "kitted", i.e. pins, shells and water proof glands ( if equipped) were all separate order items.
 
Back
Top