boatdokker
Regular Contributor
The 1985 Bayliner Capri I bought a while ago had some damage to the transom. The transom was stripped, drilled and treated with penetrating
epoxy and a few layers of fiberglass mat. The boat did not have a transom cap when I bought it, so a cap had to be fabricated from aluminum industrial trim.
What steps should be observed when installing the new transom cap? I plan on using a waterproof silicone sealant and stainless steel wood screws.
Is anything else going to be needed?
epoxy and a few layers of fiberglass mat. The boat did not have a transom cap when I bought it, so a cap had to be fabricated from aluminum industrial trim.
What steps should be observed when installing the new transom cap? I plan on using a waterproof silicone sealant and stainless steel wood screws.
Is anything else going to be needed?