Logo

15 hp Evinrude model 15704M shift rod adjustment

Mickeyfinn

New member
Hi , How do I do this? I understand about screwing it up or down and measuring the distance between the connector and housing part. But what gear should the gear case be in?
 
Correct----You screw it in and back it out as needed to put bend in the rod facing forward.------Line up the notch with hole in brass connecter before putting screw in.----Adjusting shift is done up top on the linkages under the hood.
 
Right, so many of these I work on have the little bolts hacked up, that is from not lining up the notch perfectly. If it is binding while running the little bolt in or out, then move shift rod or coupling slightly up or down.
 
Back
Top