Hey there, Great forum! Been ready for awhile and finaly posting
I baught a 1986 9.9 2 cylinder motor short shaft, Came with recepts for a recent service at a dealer. Carb kit, fuel connector, Lower end gear oil swap, plugs and greese.
Anyway second trip out it gets a little rough on the water and i accidently yanked the fuel connector out. i shut the engine off before it ran out of fuel
I replugged it in and it would start, primed the bulb and wouldnt start.
Long story short is it will run without the line connected, As soon as you plug it in the engine dies!
Any ideas? Thank you!
I baught a 1986 9.9 2 cylinder motor short shaft, Came with recepts for a recent service at a dealer. Carb kit, fuel connector, Lower end gear oil swap, plugs and greese.
Anyway second trip out it gets a little rough on the water and i accidently yanked the fuel connector out. i shut the engine off before it ran out of fuel
I replugged it in and it would start, primed the bulb and wouldnt start.
Long story short is it will run without the line connected, As soon as you plug it in the engine dies!
Any ideas? Thank you!