Captainsnail
New member
BF90D 07 fuse #2 10amp blew after 20 minutes running up the coast. replaced the fuse and it ran for another two minutes and it blew again.
not having any more fuses got a tow back and swapped one of other 10 amps to get the motor up for the trailer ride home.
fuse 2 goes through the ignition and motor tilt circuit so when it blows the engine is dead, no start or run, no motor tilt, I think it is also connected to the fuel pump.
the motor has only 148 hours on it and this is the first problem I've had, its been super reliable.
I'm new to the the site so any advice or ideas is greatly appreciated.
Thanks
Kail
not having any more fuses got a tow back and swapped one of other 10 amps to get the motor up for the trailer ride home.
fuse 2 goes through the ignition and motor tilt circuit so when it blows the engine is dead, no start or run, no motor tilt, I think it is also connected to the fuel pump.
the motor has only 148 hours on it and this is the first problem I've had, its been super reliable.
I'm new to the the site so any advice or ideas is greatly appreciated.
Thanks
Kail