There's a lot going on in the throttle linkage. Looks like 2 control arms. 1 for timing advance and 1 for carbs. I see what looks to be 3 stop screws and 1 idle screw. It also has the cable adjustment.
It's a lot going on. Is adjusting all this linkage a possible DIY project? I want to make sure it's all correct but I need to know what order these adjustments are made...
My boat has often times has been stalling at idle, when shifting. I went to adjust the idle up while on the lake and the idle was not responding when turning tha idle adjustment screw. It looked like the linkage was not returning to the seated position.
Outboard Mechanics in Atlanta are booked many weaks out so I'm tempted to give this a try.
It's a lot going on. Is adjusting all this linkage a possible DIY project? I want to make sure it's all correct but I need to know what order these adjustments are made...
My boat has often times has been stalling at idle, when shifting. I went to adjust the idle up while on the lake and the idle was not responding when turning tha idle adjustment screw. It looked like the linkage was not returning to the seated position.
Outboard Mechanics in Atlanta are booked many weaks out so I'm tempted to give this a try.