Logo

1998 2-stroke 90 hp Yamaha

dragula

New member
Recently bought the motor and have it off the old boat and almost ready to put it on my 1977 McKee craft. My boat has no gauges, and this motor came with a lot of wiring for, I assume the gauges and power tilt and trim.

i am a total newbie here. I have the throttle off the boat, the choke and throttle cables out of where it was ran in the hull, and some other power cable unplugged from the motor and out of the hull. On this wire harness/plug was a green and blue wire.

i was told that these are the down and up for the power tilt trim. I am pretty sure that they lead to a switch leading behind the steering wheel.

WTF do I do to get the whole package out. Is there a tilt/trim motor that I need to remove?
 
Turns out it was the jack plate wires. Guy had a 20” shaft motor on a 15” transom. Gonna cut the wires and take my controls.
 
Back
Top