bigdockbuilder
New member
Hello Everyone, We have a 40 hp enduro on one of our small workboat. I think its a 2000. But I will post the serial number later today.
I was running it home the other night and it started to stutter ( I assume that was possibly an overheating warning?) so I slowed right now and just idled along expecting to make it home.
Unfortunatley it overheated to the point where it just stopped. I realized then it was very hot. Some slight smoke from under the cowl and some smell.
I got towed home. Pulled the motor. Did a compression test and its 120lbs each cylinder.
I am sure some damage was done. But what ar ethe next steps. Do i pull the head off?
It was peeing water out but maybe it wasnt enough ...
Any help is appreciated.
Thank you.
I was running it home the other night and it started to stutter ( I assume that was possibly an overheating warning?) so I slowed right now and just idled along expecting to make it home.
Unfortunatley it overheated to the point where it just stopped. I realized then it was very hot. Some slight smoke from under the cowl and some smell.
I got towed home. Pulled the motor. Did a compression test and its 120lbs each cylinder.
I am sure some damage was done. But what ar ethe next steps. Do i pull the head off?
It was peeing water out but maybe it wasnt enough ...
Any help is appreciated.
Thank you.