Hi Guys
I would like to remove/replace the one piece PDS bearing on a Dpe drive which utilizes a jackshaft.
I don’t have a manual that outlines this procedure.
I have done this several times in the past on conventional stern drive set ups with the one piece bearing, but the jackshaft set up is different.
I suspect this set up requires a different procedure.
Does any one have any experience with this setup?
Thanks
Misfit
I would like to remove/replace the one piece PDS bearing on a Dpe drive which utilizes a jackshaft.
I don’t have a manual that outlines this procedure.
I have done this several times in the past on conventional stern drive set ups with the one piece bearing, but the jackshaft set up is different.
I suspect this set up requires a different procedure.
Does any one have any experience with this setup?
Thanks
Misfit