I am currently replacing the upper mounts on my new to me '84 Johnson 15 hp (J15RCRM). My question, is there supposed to be clearance between the upper thrust mount (0338631) and the upper mounts plate (0339613)
This is illustrated by the middle blue arrow in the picture, borrowed from LeeRoy's Ramblings (below)
Like the one in the photo, my plate "concaves" out towards the rear of the outboard. The rubber thrust mount can't fall out but its not held tightly in place...is this by design?
Thanks!
This is illustrated by the middle blue arrow in the picture, borrowed from LeeRoy's Ramblings (below)
Like the one in the photo, my plate "concaves" out towards the rear of the outboard. The rubber thrust mount can't fall out but its not held tightly in place...is this by design?
Thanks!