6L1 L 307065
This is my friends yamaha 93 or 94. i helped him clean the carb. he wanted to adjust it. He looked up info, but we had it wrong. Now gas floods out of breather. I would like to know proper procedures and measurement to adjust these carbs.
one last point, one thing i dont understand or like, when we fire up and get going the gas empties out of filter and never catches back up. dip tube on tank, water knock out and inline filter all replaced. gas tank diptube was cleaned.
So, I know this is our fault. he had looked up float height. with carb upside down i measured front of float to carb body. It was at 19 mm, we adjusted it to 16 mm. Obviously wrong. I would like to know correct measurement and procedure, i.e. where to measure from.
thanks in advance for any and all help.
This is my friends yamaha 93 or 94. i helped him clean the carb. he wanted to adjust it. He looked up info, but we had it wrong. Now gas floods out of breather. I would like to know proper procedures and measurement to adjust these carbs.
one last point, one thing i dont understand or like, when we fire up and get going the gas empties out of filter and never catches back up. dip tube on tank, water knock out and inline filter all replaced. gas tank diptube was cleaned.
So, I know this is our fault. he had looked up float height. with carb upside down i measured front of float to carb body. It was at 19 mm, we adjusted it to 16 mm. Obviously wrong. I would like to know correct measurement and procedure, i.e. where to measure from.
thanks in advance for any and all help.