Hi there, just thought I better check before I break something.
I am looking at replacing two mounting bolts before the heads rust away too much.
I had a bit of a go and felt that without some extra encouragement i might twist the head off the bolt.
Any suggestions on making this a safer exercise, should I just get my oxy and apply heat to help loosen it ?
Also looks like the spare from Mercury is a galvanised bolt rather than stainless, does this sound right ?
I have a picture attached outlining the ones in question
cheers
Mark
I am looking at replacing two mounting bolts before the heads rust away too much.
I had a bit of a go and felt that without some extra encouragement i might twist the head off the bolt.
Any suggestions on making this a safer exercise, should I just get my oxy and apply heat to help loosen it ?
Also looks like the spare from Mercury is a galvanised bolt rather than stainless, does this sound right ?
I have a picture attached outlining the ones in question
cheers
Mark