Logo
FULL SITE MENU

Trim Gauge for NS60A

A

Amigorick

New member
I am thinking about adding a trim gauge to my pontoon. I have a 1988 Nissan NS60A. I can find the trim gauge but is there another piece I need that goes on the motor. I have seen the term trim sending unit. Does anyone have any info on what or where that could be obtained?
 
The original tilt/trim sensor (4-wire) from 1986 is NLA. But you can use a modern 2-wire sender, wiring harness, and gauge. The meter itself is about $65.00, and is available in either black or white face. The sender kit is 3KY725750M, and costs about $91. Then get the harness, and decide whether you prefer a black or white meter.
 
Thanks!!!!


pvanv said:
The original tilt/trim sensor (4-wire) from 1986 is NLA. But you can use a modern 2-wire sender, wiring harness, and gauge. The meter itself is about $65.00, and is available in either black or white face. The sender kit is 3KY725750M, and costs about $91. Then get the harness, and decide whether you prefer a black or white meter.
Click to expand...
 
Back
Top