Hi All,
While winterizing my motor I noticed that this tube on-top of one of the heads was spewing water from splits in the hose. I was hoping to just cut the hose down to past the splits, re-insert that little bit inside the hose and push the hose back into that blue colored nut. However it doesn't slide back in. It scrunches up when I put pressure on it. I couldn't find the name of this part on any diagrams. What is this part called? How do I go about re-installing the hose?
Thanks,
Gerard
While winterizing my motor I noticed that this tube on-top of one of the heads was spewing water from splits in the hose. I was hoping to just cut the hose down to past the splits, re-insert that little bit inside the hose and push the hose back into that blue colored nut. However it doesn't slide back in. It scrunches up when I put pressure on it. I couldn't find the name of this part on any diagrams. What is this part called? How do I go about re-installing the hose?
Thanks,
Gerard
