One the many things I’m doing on the 8.1’s I bought are the outstanding recalls. There was one involving the fuse block, cut one wire and cap and then splice with another. Both engines had this done but one had a horrible, non shrink crimp thrown on. I’m going to re-do both but as you can see in the pic, I’m a little short on the red wire after I cut away the old butt connector.
I never use solder but that could do that in this case. Or, does anyone know what company made these fuse blocks? I could get another one or just replace the short wire if I could figure out how to get it apart. Crusader does not show this as a separate, it’s just part of the harness.
thanks
Bob
I never use solder but that could do that in this case. Or, does anyone know what company made these fuse blocks? I could get another one or just replace the short wire if I could figure out how to get it apart. Crusader does not show this as a separate, it’s just part of the harness.
thanks
Bob
Last edited: