I Installed a new trim motor, relay and replaced the ground wire on the bottom of the PTT. Previous motor would only work if I hit it with a mallet.
Now the motor will trim up just fine but will not trim down at all. It makes no noise at all when I press the switch down. I have searched google for hours and still can not find a solution. Does anyone have an idea of what I should look at next?
Now the motor will trim up just fine but will not trim down at all. It makes no noise at all when I press the switch down. I have searched google for hours and still can not find a solution. Does anyone have an idea of what I should look at next?