Logo

'63 Gale 5hp propeller

i acquired a NOS PJ300 prop that appears to be the same size/configuration except that the casting at the shear pin is not grooved for the rubber prop cap. i assume it will require the hard cap with the indents for a cotter pin. do you know the Gale/OMC part number for that?
 
Is the groove for the rubber cap not on the propshaft ?----Pictures of the prop and propshaft ?

ya know, sometimes i feel as if i'm not firing on all cylinders...this is one of those times. my dumb ass didn't pull the cone yet...and yes, you are most certainly correct. this is a cut twice, measure once event. thanks! LOL
 
Back
Top