Walleye4Days
Contributing Member
So, I pulled the engine and refreshed her. New timing chain, new seals from the block up, and cleaned and inspected all the internals. After putting in new pds bearings and seals, I am trying to reinstall the engine.
But I just spent the better part of 3hrs with a buddy, trying to drop the AQ225D back in and carnot for the life of me get the engine coupler and splines to cooperate. I get the engine down to the stringers and in place no problem, but I cannot get the splines and coupler to line up...
Is there some kinds of trick I'm missing or something? (Both the coupler and splines are cleaned and greased, but but still not able to get them mated.
But I just spent the better part of 3hrs with a buddy, trying to drop the AQ225D back in and carnot for the life of me get the engine coupler and splines to cooperate. I get the engine down to the stringers and in place no problem, but I cannot get the splines and coupler to line up...
Is there some kinds of trick I'm missing or something? (Both the coupler and splines are cleaned and greased, but but still not able to get them mated.