Logo

1960 Chris Craft Paragon 25XE rear seal

pollack137

New member
Hi, I have a 1960 Chris Craft Capri with a 283 flywheel forward engine and direct drive paragon 25XE manual transmission and an have searched for days for a part number for the rear output shaft seal. If anyone could help direct me to a parts catalog or knowledgeable parts supplier I would greatly appreciate it.
 
check with the folks at Hale marine, in VA.....they can fix nearly any marine gear and have been around a long time....
 
Ayuh,...... Mic up the shaft, 'n seat, then call Baum Bearing, 'n iron works in Nebraska,..... Lincoln I think,....

Give them the dimensions, 'n they'll most likely have one to fit,....

I use them for alotta can't be found seals for all sorta equipment,..... 'n they've never let me down yet,....
 
Thanks, That is the route I will go. I have a few contacts close to home but will definitely give Baum Bearing a call if i can't sort things out.
 
Back
Top