Honda BF40 - Wiring kill switch and oil light

Hey folks,

I've got a remote motor more or less converted to tiller, but I've having difficulties wiring in the kill switch and oil light. There was no kill switch on the tiller, so I bought a replacement, but it didn't come with wiring instructions. This is what I've working with



Obviously I just ground the black wire, but any idea where the white goes?

Same question again, but with the oil light



And I'm guessing they plug in here somewhere, but I don't know where and I haven't been able to find a wiring schematic for it. Any ideas?



Thanks,

Cory

To make your kill switch work you need to connect it to the Black/red wire that goes into the remote harness plug, so will have to cut it a use a female bullet connector to mate with the one on the white wire you show in the first photo. As far as the oil light is concerned, check the colors to the oil light in your remote control and splice into them in the engine harness. Even the genuine Honda manuals don't have a wiring diagram for that motor, strange.