nicolai2912
New member
Hi there.
I have a Omc 3.0 from 1993
So i just replaced my lower shift cable, with the correct adjustment tools.
After replacement of the cable the boat shifts fine into gear, however the interupter switch keeps being activated, so if cuts off the engine when in gear.
I had the same problem before replacing the cable.
however it only seems to activate the interupter switch when going into FWD, and dosent move the bracket at all when going into reverse.
Also after the first run the cable seems to be alot harder to when tryning to go into FWD movement
What could be the problem?
I have a Omc 3.0 from 1993
So i just replaced my lower shift cable, with the correct adjustment tools.
After replacement of the cable the boat shifts fine into gear, however the interupter switch keeps being activated, so if cuts off the engine when in gear.
I had the same problem before replacing the cable.
however it only seems to activate the interupter switch when going into FWD, and dosent move the bracket at all when going into reverse.
Also after the first run the cable seems to be alot harder to when tryning to go into FWD movement
What could be the problem?
Last edited: