doc_stressor
Member
I need to adjust the throttle tension on my new BH250D. When I remove the upper and lower screws that hold the cover in place on the control box, I still can't remove the cover. Is there anything else holding the cover in place before I whack it or try to pry it off? There are 4 small holes at the bottom of the cover, 2 on each side. I'm concerned that these may be tiney set screws. There is nothing like them shown in the parts blowup.
The shop manual for the BH250D is not available yet, so I'm afraid that I might break something.
The shop manual for the BH250D is not available yet, so I'm afraid that I might break something.