1982 aq125a engine triangulation engine is too far down to left

I lined up the tabs on flywheel housing but engine is not level. left side is down too low. Thanks, Bill

Is this a cantilever style mounted engine?
If so, loosen and twist engine until aligned.

Let me further explain my post #2.

Most of these little OHC 4 bangers were mounted conventionally with front/side engine mounts and a single AFT Flywheel Cover/Transom Shield mount.
However, some were suspended from the transom and transom shield ONLY, and did not use a front or side engine mount system.

In either case, you will be able to adjust the engine CW or CCW a small amount.
Once aligned, then fully tighten the 6 clamping collar bolts.

Be sure to install at least one new large rubber cushion ring...... and that would be the FWD ring between flywheel cover and transom shield.


.

OMG, if I hit the lottery, U are first on my list to get part of it. I thought I really screwed up but U saved the day. Many, many Thanks, BILL