Hi there, looking for a little advice on my changeover outboard project
I had a 35hp Evinrude(1980's) that has tanked. So I purchased an Evinrude 28hp (Model #E28ESLEDR 1996) to replace.
The controls for the old motor are still in place so I'm hoping that I can place the 28hp right on and connect the gear and throttle cables with no worries (I'm assuming they are pretty much the same.
As well, I have an OMC power tilt and trim that was hooked up to the 35hp that I'm hoping to keep as it worked great. Just wondering if anyone knows where I can find a bracket to fit the 28hp? Seems there are no holes for this bracket on 28hp. I have attached pictures for assistance with understanding my dilemma.
Thanks for viewing
I had a 35hp Evinrude(1980's) that has tanked. So I purchased an Evinrude 28hp (Model #E28ESLEDR 1996) to replace.
The controls for the old motor are still in place so I'm hoping that I can place the 28hp right on and connect the gear and throttle cables with no worries (I'm assuming they are pretty much the same.
As well, I have an OMC power tilt and trim that was hooked up to the 35hp that I'm hoping to keep as it worked great. Just wondering if anyone knows where I can find a bracket to fit the 28hp? Seems there are no holes for this bracket on 28hp. I have attached pictures for assistance with understanding my dilemma.
Thanks for viewing