I went to trim up the motor and it moved a little going up then stopped. It moved going down. I checked the fluid level and it was full. I figured something inside the trim motor may have failed even though it ran. I ordered a replacement and installed it. Runs up and down, but the motor doesn't m ove at all? Manual vent is closed. Thoughts on whether or not the o-rings are bad or am I out of luck? Not going to spend $1200 on a new one right now.
Mercury ELPT/BF4, 40 EFI, 1A41452EZ
Mercury ELPT/BF4, 40 EFI, 1A41452EZ