Logo

1969 Chrysler 318

Rub

New member
Hi, I’m new here.. I just installed a Pertronix distributor in our house boat, and a .6 ohm, 45,000 coil.. I need to eliminate the the ballast resistor, can anyone tell me where the wires from the resistor now go?? I was gonna put them on the coil but I’m not sure if that’s right.. Tks in advance..
 
Last edited:
I apologize if it’s already been asked or if it’s a dumb question.. I don’t know a lot about wiring and don’t wanna screw it up..
 
Back
Top