Logo
Click for Chrysler parts and manuals!
Results 1 to 2 of 2
  1. #1

    Default 1969 Chrysler 318

    Hi, I’m new here.. I just installed a Pertronix distributor in our house boat, and a .6 ohm, 45,000 coil.. I need to eliminate the the ballast resistor, can anyone tell me where the wires from the resistor now go?? I was gonna put them on the coil but I’m not sure if that’s right.. Tks in advance..
    Last edited by Rub; 05-05-2019 at 10:55 AM.

  2. #2

    Default Re: 1969 Chrysler 318

    I apologize if it’s already been asked or if it’s a dumb question.. I don’t know a lot about wiring and don’t wanna screw it up..

Similar Threads

  1. 1969 Chrysler 9.9 parts help
    By Donegaldave in forum Chrysler Force Outboard Forum
    Replies: 3
    Last Post: 08-09-2016, 05:52 AM
  2. 85hp Chrysler 1969
    By shroom in forum Chrysler Force Outboard Forum
    Replies: 0
    Last Post: 06-16-2010, 05:58 PM
  3. 1969 chrysler motor
    By andredesc in forum Chrysler Force Outboard Forum
    Replies: 3
    Last Post: 08-18-2009, 12:14 AM
  4. 1969 chrysler sat for 10 years
    By mark sube in forum Chrysler Force Outboard Archive
    Replies: 1
    Last Post: 08-24-2008, 11:46 PM
  5. 1969 35 HP CHRYSLER HELP
    By evolution 8 in forum Chrysler Force Outboard Archive
    Replies: 1
    Last Post: 10-01-2006, 01:00 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •