Logo

Advice needed

Colly

New member
I have a ford mermaid 2711E model which I have taken out of my boat and I am wondering if a ford 2712E model will fit on the mountings for engine, also will a Borg Warner gearbox fit as I am planning to remove from the mermaid 2711E and fit the ford sabre 2712E thanks
 
Colly, Yes the engine block is identical, but the bolt on supports may be different dimensions so just swap them. Also the trans to flywheel housing are identical, but on some engines a 200# flywheel was used. It also is interchangeable and i suggest using it as it cuts down on vibration.
Charlie W
 
Back
Top