bigjohnson
Regular Contributor
Got a WELL used motor for cheap the other day and have been trying to clean and get it started. I don't have any paper work on it so I'm doing the best I can. First, there's NO SPARK but this may be because it came with NO KEYS. Can someone tell me which keys I will need and what each component does?
The one on the far left can I just (for now) splice a wire into the two slots to complete the circuit? The next one has a spring loaded button that I'm assuming has to be held down while starting so needs a locking key for that??
Also, the kill button on the END OF the TILLER handle seems stuck. Can I just back track those wires and unplug them for now so it's not killing the engine?
Is there a OHM reading for the coils so I can check to see if they are good?
I am looking for a repair/owners manual. Thanks
The one on the far left can I just (for now) splice a wire into the two slots to complete the circuit? The next one has a spring loaded button that I'm assuming has to be held down while starting so needs a locking key for that??
Also, the kill button on the END OF the TILLER handle seems stuck. Can I just back track those wires and unplug them for now so it's not killing the engine?
Is there a OHM reading for the coils so I can check to see if they are good?
I am looking for a repair/owners manual. Thanks