Gateway for 6.0 crusader engines

Hi,

I just installed a pair of new 6.0 crusader engines with Sync and cruise and am wanting to connect them to my MFD.

Has anyone got any idea and possibly a wiring diagram on how to do this?

I notice that there is a 3 wire DIN plug that is not used with the Sync/Cruise wiring harness....

Thanks

I'd say you need to check with whoever's MFD you have and see if they have the interconnects already done.

If not, you need to figure out what protocols the MFD will handle and then see if what your current engines' ECUs provide. from there, it could be a simple as adding a couple cables....could be as complicated as adding a full-up network and some trial & error configuration settings....

Without specific model numbers, etc., its really hard to tell - like other consumer electronics areas, the state of the art is continually evolving.