Logo

1967 Evinrude Fastwin 18 HP Rubber Mounts

dtvic

New member
I have a 1967 Evinrude 18 HP Fastwin and am trying to get running as best I can. The last time I had it running in the lake I had the engine cowl off so I could adjust the idle jet I noticed a loud nocking noise that did not happen when the cowl was on the engine. Well it turns out the four rubber mounts that hold the lower part of the cowl down have given up. The two on the rear are totally parted and the two in the front are not vert ridged and are about to separate. the part number of the replacement rubber mounts is 377582 or 0377582. So I would like to know if the whole lower unit needs to come off or the power head be removed? Any ideas from anybody who has made this repair would be well received.

Dave
 
Back
Top