Logo

Getting hot

skeeter11

New member
So I have a 25 (m25c3). After running about a mile it starts to rattle (like two pieces of tin hitting each other) and then dies. It will start back up but will only run close to idle. I've done the usual pump, t-stat and found the water tube pushed up inside the housing. Good water pressure now. Fixed that. I took the head off to look at the gasket and found zero problems.
There looks like a small crack in both cylinders. TIA
 
Upper cylinder get bad hot. Like if you threw water on a skillett. The cracks are not casting marks. They are irregular but straight. If I knew how to do a pic I would. TIA
 
Back
Top